Good morning Carlos

Was the electric on today

WiFi info- Unifi 10672025

How is it going there?

Ok thank you

Yes I’ve asked, I’m still waiting for it. I should have it in the next hour

Wait let me check and get back to you

It would on the front

Hi Vlad Mimi / Phil Blancett 4701 Leilani Lane

Can you send me the width?

I will buy another

Yes remove it

Ok 5mins

Can you bring in the trash cans

I just stopped by Stonefield

Please do that first what I sent above, if they charge us for that it will be billed to you

Saturday Nov 1 they can come

4. Clean the filter • Rinse it thoroughly under warm water. • Use an old toothbrush or small brush to scrub off any residue. • Check inside the filter housing (the opening) for debris too — sometimes small items (like a sock tag or hairpin) get stuck in there. ⸻ 5. Reinstall the filter • Once it’s clean, push it back in and twist it clockwise until snug. • Close the drain hose cap and tuck it back into place. • Snap the access panel closed. ⸻ 6. Test the washer • Plug the washer back in. • Run a Rinse + Spin or Drain + Spin cycle to check if it drains properly. If it still isn’t draining: • Check the drain hose (the one that connects to your wall drain) for kinks or clogs. • Make sure the hose isn’t inserted too far down into the drain pipe — that can cause siphoning. • If you still hear the pump running but no draining, the drain pump itself may be blocked or need replacing. ⸻ ✅ Quick tip: Clean the drain filter every 1–2 months to prevent future clogs — especially if you wash pet bedding, lint-heavy items, or small garments.

If your Samsung washer isn’t draining properly, a clogged drain pump filter is one of the most common causes. Here’s exactly how to clean it safely 👇 ⸻ 🧺 Step-by-Step: Clean the Drain Filter on a Samsung Washer ⚠️ Before you start: • Unplug the washer or turn off the power. • Turn off the water supply (just to be safe). • Have a towel and a shallow pan or bowl ready — some water will spill out. ⸻ 1. Locate the drain filter • It’s usually behind a small access panel on the front bottom right of the washer (beneath the door on front-load models). • Push or pull the panel open — sometimes there’s a small notch you can use a coin or flat screwdriver to open. ⸻ 2. Drain excess water • You’ll see a small rubber drain hose next to the filter cap. • Pull the hose out gently, remove the plug, and drain the water into your pan/bowl. • This may take a few minutes if the washer was full of water. • When it stops draining, replace the plug and push the hose back in. ⸻ 3. Remove the filter • Twist the filter cap counterclockwise and pull it straight out. • You’ll probably see lint, coins, hair, or other debris caught in it.

I’m booking appt now but I would recommend to clean the drain filter if there’s any blockages

Have you tried to cleaned the drain filter?

This is the measurement for potential fridge - 28 11/16” x 35 13/16” x 69 7/10” Please let me know if this will work

Hi Taka! I see there is more room at the top, can a fridge with a height of 69 7/10in fit?

I’m checking on that. Will get back to you

Good morning, is there a possibility I can come a little earlier? 10-10:15AM

Does that work?

I can do 10:30AM